sides were stripped to bare metal.
Here's a shot of the passenger side. Note the rust in the corner.
was filled with a blob of unidentifiable material that was
supposed to seal it. It didn't.
A little tighter shot, you can see that there is significant
rust damage here, really all caused by that sealant. It
was rock hard, very difficult to remove and apparently
porous.
The upper section of the buffer area near the corner
of the engine bay drain channels. The square shaped
hole in the upper right of the picture was filled with a
similar kind of sealant that had failed allowing water
to collect water.
A shot of the sill from the bottom.
A view of the drivers side, the condition was very similar
to the passenger side. Same damage in the corner.
This is the bottom rear area of the wheel well. The undercoat
was loose along the bottom edge so I removed it all, not
easy! But the undercoat did it's job, the metal underneath
came out nice.
Same area on the passenger side.
No comments:
Post a Comment